Memmert CO2 Incubator 108L
- uniform atmosphere and temperature distribution owing to enclosed, non-turbulent ventilation system in working chamber
- adaptive, fuzzy-supported, multifunctional, digital microprocessor PID-controller
- integral fault diagnostics on temperature, CO2 and humidity limit control
- 2 Pt100 sensors Class A in 4-wire-circuit, mutually monitoring and taking over the performance at the same temperature value
- digital 7-day-programme-timer with real time clock, precise minute setting
- digital display (LED) of all set parameters, such as temperature, weekdays, time, CO2, humidity and set-up values – language to be chosen in setup
- CO2-supply via sterile filter
- digital electronic CO2 control with automatic zeroing (infrared measuring system) – range of adjustment 0-10% – resolution 0,1%
- intrinsic adjustment of altitude above sea level
- CO2-supply being interrupted upon door opening
- digital display of set and actual values (LED) of temperature (0,1 °C resolution) and of CO2-concentration (0,1%)
- integrated humidity limit control (88-97%) with digital display of relative humidity – resolution of display: 0,5%, setting accuracy: 1%
- programme stored on power failure
- chip card (STERICard) for sterilisation of working chamber with fixed cycle (4 hrs./160 °C) without removal of sensors and mountings
- large-area multi-function heating system with additional door and back heating to avoid condensation
- incl. works calibration certificate for +37 °C
- with audible and visual alarm in case of over-/undertemperature and over-/under-CO2, open door and empty gas cylinder
- independently working, digitally adjustable electronic overtemperature controller TWW protection class 3.1
- additional integral over- and undertemperature monitor “ASF” (Auto-Safety-Function) automatically following the setpoint value at a preset tolerance range; audible alarm is activated in case of over- or undertemperature, heating is switched off in case of overtemperature
- resolution of display and setting accuracy: 0,1 °C
- mechanical temperature limiter TB protection class 1 switching the heating off at approx. 10 °C above max. oven temperature
- w x h x d: 710 x 778 x 550 mm
- fully insulated stainless steel door with double locking and 4-point adjustment
- inner glass door with opening (8 mm dia.) to take gas samples
- rear zinc-plated steel
- w x h x d: 560 x 480 x 400 mm, 108 l
- easy-to-clean interior, made of stainless steel, reinforced by deep drawn ribbing, material no. 1.4301 (ASTM 304), hermetically welded
- 2 perforated stainless steel shelves, 1 stainless steel water dish
- from +20 °C (however, at least 8 °C above ambient temperature) up to + 50 °C
- temperature variation in time: < +/-0,1 °C (to DIN 12 880: 2007-05)
- temperature uniformity in chamber at 37°C: < +/- 0.3 °C (to DIN 12 880: 2007-05)
- 230 V (+/- 10%), 50/60 Hz
- ca. 1.000 W (during heating)